This functionality is only available for certain module packages. Info / Copyright

Swapping Function Definitions

You can switch the assigned function definitions for a function. Only those function definitions are offered which match the correct number of connection points. The number of connection points of the new function definition must be the same or greater than those of the symbol used. For instance, it is possible to use the function definition "change-over contact" for an NO contact.

If the function should have fewer connection points than the symbol used, you need to switch the symbol. The new symbol then brings the new function with it.

You can also exchange function definitions using search and replace.

Precondition:

You have placed a function (i.e. a component) on a schematic page. Or you have generated a function in one of the navigators.

  1. Select the function.
  2. Select the menu item Edit > Properties.
  3. In the Properties <...> dialog, in the Symbol / function data tab, click [...] next to the Definition field.
  4. In the Function definitions dialog, page through the tree and select the desired function definition.

    In the tabs to the right of the dialog, the properties and connection point data of the selected function definition are displayed.
  5. Click [OK].
  6. If necessary, edit the connection point data in the Connection point logic dialog, or switch the symbol.
  7. Click [OK].

See also