You use check run schemes for the project verification in order to specify which runs EPLAN should execute.
Preconditions:
- Project > Management
- Select a project.
- Select [Extras] > Verify project.
- Click [...] next to the Perform project checks field.
- Next to the Scheme field click
(New). - In the New scheme dialog, enter a recognizable name for the new scheme in the Name field and click [OK].
- Select a message class in the Class column.
The table on the right side of the dialog shows the messages possible for this class. - Use the drop-down list in the Category column to specify for each message whether the message should be displayed as an error, a warning, or a note.
- Use the drop-down list in the Type of check column to determine whether the check should be run both online and offline (setting "Online / offline") or only offline (setting "Offline"), or whether the corresponding check should not be run (setting "No").
- Click [Save] and then click OK.
Verify project
See also
Comparison Project and Incoming Project