This functionality is only available for certain module packages.

You are here: Tutorial > EPLAN Pro Panel > Expanding the mechatronic model with EPLAN Pro Panel components > Installing discipline components for sensors

Installing discipline components for sensors

All of the terminal clamps that can be assigned to a sensor are installed in the respective sensor.

  1. Change to the Engineering perspective.
  2. Open the Positionsensor_inductive component.
  3. Drag the Terminal_PxC_3031212 component from the ECAD > ProPanel unit to the component editor three times.
  4. Name the installed components as follows:
Old name New name
Terminal_PxC_3031212 X1L+
Terminal_PxC_30312122 X1M1
Terminal_PxC_30312123 Input
  1. For the Position parameter of the installed components, enter the value 300.
  2. Repeat steps 2 to 5 for the Positionsensor_optical component.
  3. Open the Pressuresensor component.
  4. Drag the Terminal_PxC_3031212 component from the ECAD > ProPanel unit to the component editor two times.
  5. Name the installed components as follows:
Old name New name
Terminal_PxC_3031212 X1L+
Terminal_PxC_30312122 Input
  1. For the Position parameter of the installed components, enter the value 300.