EPLAN allows a schematic to be automatically generated from (e.g.) a bus configuration. Unplaced PLC functions (or those that are unplaced in particular representations) are automatically placed, thus allowing PLC schematics with different overview pages to be generated. The following editing options are available:
- Schematic pages with different representation types can be generated.
- The PLC functions allow macros to be automatically assigned (from the part) or manually assigned.
- Value sets can be selected for variables in the macros contained by placeholder objects, or values can be manually entered.
- Wiring macros allow the wiring of the connection points to be displayed.
- The bus configuration can be created using special configuration programs and then imported into EPLAN and used to generated a schematic.
- Objects subsequently entered into the bus configuration can also be automatically inserted into the schematic. You can generate new pages for the newly added objects, or regenerate a range of pages, or regenerate the entire PLC schematic.
- PLC addresses can be imported from an assignment list and the device selection can then be used to generate unplaced PLC functions for these addresses. These functions can be automatically placed by the PLC schematic generation.
- The configuration defined in the Generate PLC schematic dialog can be saved, imported, and exported. You can interrupt your schematic planning and resume it at a later date.
- Automatically placed functions generated by the PLC schematic generation can be deleted and placed again.
- The properties dialog can be called up in the "Global" mode and you can then use this to edit the device properties.
See also
PLC Schematic Generation: Principle
Macros for PLC Schematic Generation