This functionality is only available for certain module packages. Info / Copyright

Using Main Terminals

The main terminal represents a terminal device on a terminal strip. A device can contain any number of main terminals but only one main function. Therefore the terminal strip is defined as a main function and the terminals as main terminals or auxiliary terminals. If a terminal is defined as a main terminal, then it behaves in a similar manner to a main function. For example, for a main terminal the function templates are displayed in the terminal strip navigator, and a device selection can be performed.

Independent areas of a terminal strip

The use of main terminals divides a terminal strip is divided into "independent areas". An independent area corresponds to a terminal device, which may be formed from several functions. Terminal devices are additionally identified through the Terminal: Device position property. Normally all the terminals of an independent area have the same device position and there is only one main terminal per terminal device. A terminal strip can contain any number of main terminals and therefore any number of independent areas. When you insert a terminal, it is inserted as a main terminal by default. Therefore an independent area is created for each terminal. You can change a terminal into an auxiliary terminal by deselecting the Main terminal check box in the property dialog for the terminal.

An independent area extends from one main terminal (including the terminal) to the next main terminal (at the same device position). It therefore contains one main terminal and the associated auxiliary terminals. If the first terminal on the terminal strip is not a main terminal, the first area of the terminal strip (i.e. the area from the start of the terminal strip to the first main terminal) is defined by the terminal strip definition. If there are no main terminals, the whole terminal strip forms just one area which is entirely defined by the terminal strip definition. If there is no terminal strip definition, no function templates are available for the first area of the terminal strip.

You can use the Do not use main terminals property to specify that a terminal strip should not be divided into independent areas and should only be defined via the terminal strip definition. The function templates of the parts entered at the terminals are not used, but the parts are output in reports. In addition, free function templates are re-used when copying and pasting terminals.

Definition of multi-level terminals

Independent areas can be used to define multi-level terminals. A multi-level terminal consists of several consecutive terminals in one area, each with consecutive levels. The level number can be ascending or descending in the process. Terminals in different areas cannot belong to the same multi-level terminal. This means that every multi-level terminal can contain only one main terminal; its associated terminals must be auxiliary terminals.

Assign the function templates

If parts containing function templates are entered at the terminal strip definition or at the main terminals, these function templates are superimposed by the terminal functions within the independent area in question. Assignment does not extend beyond the boundaries of the area, even though suitable functions may be available there.

We recommend that a terminal strip should be constructed entirely from main terminals (and their associated auxiliary terminals) or completely without main terminals. This means that the terminal strip should be defined either by the independent areas of the main terminals alone or by the terminal strip definition. It is possible to mix these components but this is less clear for assignment of the function templates. In the first case, enter parts at the relevant main terminal but not at the terminal strip definition. The function templates of the part are superimposed by the terminal functions of the main terminal and of the associated auxiliary terminals. In the second case, enter the part at the terminal strip definition and nowhere else. The function templates of the parts are superimposed by the terminal functions of all the terminals on the terminal strip.

Note:

When working with the 3D mounting layout navigator, you should enter the parts at the main terminals (and not at the terminal strip definition). This is the only way of making the terminals visible in the 3D mounting layout navigator as it only displays devices to which a part has been assigned. This is a basic condition for interfaces with external terminal configuration programs.

Device selection

During device selection, function templates are only assigned within an independent area. Multi-level terminals are retained and are not pulled apart.

See also