Cause
You entered the same connection point type of the function connection points of a connection's targets. You also gave the connection a connection definition point and a function definition which doesn't correspond to the connection point type of the targets.
Note:
This message is not output under the following conditions:
- the connection is of type "Jumper"
- the connection is of type "Saddle jumper"
- the connection is of type "Wire jumper"
- the connection is of type "Switching jumper"
- the connection is of type "Internal jumper"
- the connection is of type "Insertable jumper"
- the connection is of type "Direct connection"
- the connection is of type "Undefined"
- the connection point is of type "Undefined".
Solution
Assign the same connection point type to the connection definition point and the connection targets.
Refresh the connections and then start a new check run.