Cause
A connector with at least one unconnected connection point was found in the schematic. For the purposes of this message, a connector is an angle, T-node, jumper, double junction or diagonal connection.
Example:A T-node in the schematic has an unconnected connection point (see circle in the following figure).
Solution
- Locate the relevant connector in the schematic using the Go to (graphic) function from the popup menu in the Message management dialog.
- Connect the open connection point(s) of the connector with a component so as to form autoconnecting lines.
- Delete the connector if it is no longer required.
- Then start a new check run.