Cause
A text was found in the schematic whose text angle is not equal to 0° or 90°.
Solution
- Locate the text in the schematic using the Go to (graphic) function from the popup menu in the Message management dialog.
- Open the Properties <...> dialog of the text, and bring to front the Format tab.
- Assign the value 0,00° or 90,00° to the Angle property.
- Close the Properties <...> dialog by clicking [OK].
- Then start a new check run.
Notes:
- The check run is carried out for text on the following page types:
- In the case of docked property texts, only the text of the main property is checked.
- The check does not include texts of dimensions, texts within blocks, and texts within embedded reports.
- Schematic multi-line
- Schematic single-line
- Fluid power schematic
- Overview.