Cause

A text that is displayed truncated with an activated alignment box was found on a project page.

Solution

Locate the text in the project using the Go to (graphic) function from the popup menu in the Message management dialog.

Several solution options are available. These are described below:

Possibility 1

You enlarge the alignment box.

1. Mark the text on the project page so that the element points of the alignment box become visible.
2. Position the cursor on one of the element points, press the left-hand mouse button and drag the alignment box in the desired direction until the text lies completely within the alignment box.
3. Then start a new check run.

Alternatively you can also change the size of the alignment box by using the Width and Height format properties in the dialog Properties <...> of the text.

Possibility 2

You reduce the font size of the text

1. Open the Properties <...> dialog of the text, and bring to front the Format tab.
2. Reduce the value entered in the Font size field until the text fits in the alignment box.
3. Close the Properties <...> dialog by clicking [OK].
4. Then start a new check run.

Possibility 3

Fit the text in the alignment box.

1. Open the Properties <...> dialog of the text, and bring to front the Format tab.
2. Activate the Text fitting permitted check box.
3. Close the Properties <...> dialog by clicking [OK].
4. If the text is located on a schematic page, select the menu items Edit > Text > Fit texts in alignment boxes.
   If the text is located on a report page, generate the report again.
   
   The size of the text is adapted automatically to the size of the alignment box.

5. Then start a new check run.