Cause
The connection definition point of a conduit connection no longer lies on the interface of the conduit definition line anymore. EPLAN can therefore not assign the connection definition point to a conduit.
Solution
- Locate the connection definition point in the schematic by using the Go to (graphic) functionality from the popup menu in the Message management dialog.
- Move the connection definition point to the interface of the conduit definition line with the conduit connection or redraw the conduit definition line.
- Refresh the connections and then start a new check run.
Note:
If the moved connection definition point of a conduit connection has the same DT as the conduit definition, the connection is assignable to the conduit. Accordingly the message is not output.