Open topic with navigation

This functionality is only available for certain module packages. Info / Copyright

P026044: No connection point pattern defined.

Cause

No connection point pattern has been defined at the part placement in the layout space.

Solution

Store a connection point pattern on the part placement.

Possibility 1

  1. Locate the part placement in the layout space using the Go to (graphic) function from the popup menu in the Message management dialog.
  2. Open the Properties <...> dialog of the part placement.
  3. Bring the Part tab to the front, remember the part number assigned there, and close the property dialog.
  4. Select the Utilities > Parts > Management menu items, and navigate in the tree view of the Parts management dialog to the part that you have remembered.
  5. Bring the Technical data tab to the front, and next to the Connection point pattern field click [...].
  6. Select in the Select connection point pattern dialog that opens the name of the required connection point pattern and click [OK].

    The name is transferred to the Connection point pattern field of the Technical data tab, and the connection point pattern is assigned to the part placement in the layout space.
  7. Close parts management, save the modified data, and update the parts database.
  8. Then start a new check run.

Note:

If no connection point pattern has been stored in parts management, it will have to be created subsequently. Proceed as follows:

  1. Select in the tree view of parts management the Connection point pattern hierarchy level, and select the New popup menu item.
  2. Define the required connection point data on the tabs Connection point pattern, Connection points, and / or Attributes, enter a name for the connection point pattern, and click [Apply].
  3. Select in the parts tree the part, and assign to it the connection point pattern - as described above.

    The assignment is then also implemented for the part placement in the layout space.

Possibility 2

  1. Open the Properties <...> dialog of the part placement.
  2. Bring to front the Connection point pattern tab.
  3. Activate the Local connection point pattern check box.
  4. Enter the required connection point designations in the table together with other connection point data.
  5. Close the Properties <...> dialog by clicking [OK].
  6. Then start a new check run.