Cause

During the export of the wire fabrication data, a missing and / or incorrect setting was determined.

The placeholder <x> in the message specifies which setting is missing or which setting's value is too high. The following placeholders are possible:

• Missing cross-section
• Komax data for wire could not be determined
• Missing length
• Machine command target unknown
• Machine command source unknown
• Maximum cross-section exceeded
• Maximum length exceeded
• Machine data for wire could not be determined
• Bundle split - number of wires too high
• Wire termination processing target missing
• Wire termination processing source missing.

Solution

1. Complete and / or correct the setting for the export of the wire fabrication data according to the placeholder text.
2. Export the wire fabrication data again.