EPLAN Pro Panel allows for the output of manufacturing data for wire fabrication machines of different manufacturers and for sharing it with service providers:
Each of these formats must be licensed as separate interfaces.
In addition, it is possible to configure and output a "General wires parts list". The exported file can be used by manufacturing machines, which interpret this format, for the purposes of automatic cutting to length, labeling and production of conductor ends of cables. The wires parts list contains all information on connections between devices, their part numbers, their flows and length:
- Wire number
- Starting device with unique DT
- Connecting point of such device
- Target device with unique DT
- Connecting point of such device
- Part number of the wire
- Length of wire
- Starting direction from the connecting point of the first device
- End direction to the connecting point of the second device
- Bundle number.
For all machining exports from EPLAN Pro Panel, the final message is contained in a dialog which lists specific information on the exported components or states reasons why certain components could not be exported. This dialog displays the following information:
- Name of the exported format
- Name of the used scheme and the set output path
- Number of exported components
- Alternative exports
- List of all components which were not exported including the reasons why they were not exported
- Reference to system messages if any have occurred.
See also