For each function definition, ten sets of connection designations and connection descriptions can be specified. These sets can then be selected later on from the function.
Create connection point designations
Precondition:
You have opened a project.
- Select the following commands: Tab Master data > Command group Symbols > Connection point designation.
- Select the Connection point designations tab.
The Connection point designations tab lists the function definitions with their connection points. One line is shown for each connection point. - In the fields 1 - 10, enter up to 10 different connection point designations per connection point.
- Click [OK].
Create connection point descriptions
Precondition:
You have opened a project.
- Select the following commands: Tab Master data > Command group Symbols > Connection point designation.
- Select the Connection point descriptions tab. The Connection point descriptions tab lists the function definitions with their connection points. One line is shown for each connection point.
- In the fields 1 - 10, enter up to 10 different connection point descriptions per connection point.
- Click [OK].
Note:
After each change, the changed connection point designations / descriptions must be exported. If you receive a new function definition library in an update, you will need to import your exported connection point designations / descriptions into the new program version and add the new function definitions.
See also