This functionality is only available for certain module packages. Info / Copyright

P501009: The drilling pattern <x> entered at the part does not exist

Cause

In the parts database to be checked a part was found where a drilling pattern was entered which EPLAN cannot find.

Solution

  1. In the message management dialog mark the line with the message and select the Properties popup menu item.

    The Parts management dialog is opened, the respective part is already marked in it.
  2. Bring the Manufacturing tab to the front.
  3. In the Name (drilling pattern) table column, click [...].
  4. Select the required drilling pattern from the selection dialog opened.
  5. Close the parts management, save the modified data, and carry out a parts synchronization.
  6. If required, start a new check run.