This functionality is only available for certain module packages. Info / Copyright

P024010: Invalid conduit length

Cause

At a conduit definition a negative value for the conduit length was entered.

Solution

  1. Locate the conduit definition line in the schematic by using the Go to (graphic) functionality from the popup menu of the Message management dialog.
  2. Open the property dialog of the conduit definition line.
  3. Enter a positive value in the Length field.
  4. Click [OK].
  5. If required, start a new check run.

Note:

Other invalid values, for example letters, are not accepted. Invalid values that include interpretable units, are automatically corrected. For example the input 2M turns into length 2 m.