Cause

For the connection point <x> of a part placement, the number of routing connections that can be wired to the connection point has been set in the connection point pattern, in the Max. number of wires column. However the actual number of routed wires connected to this connection point is higher than specified.

Solution

Possibility 1

Check the target wiring in the multi-line schematic, meaning the use of the connection symbols (T-nodes, angles, etc.), and correct it if necessary.

Possibility 2

Increase for the connection point concerned in the connection point pattern the value in the Max. number of wires column. Specify at least the number of the actually routed wires connected to the connection point.

---

If required, start a new check run.