This functionality is only available for certain module packages. Info / Copyright

P032001: Drilling pattern could not (or not completely) be created. <x>

Cause

Several causes are possible. These are output in the placeholder <x> of the message:

  • No drilling pattern name available.
  • Block not broken up.
  • Outline not closed.
  • No cut-out identified.

Solution

Depending on the respective cause the following solutions are possible:

  1. First locate the drilling pattern frame in the project using the Go to (graphic) function from the popup menu in the Message management dialog.

    - Enter a name in the dialog Properties <...> of the drilling pattern frame.

    - Or break up the block into individual elements.

    - Or close the outline.

    - Or check the layer allocation of the objects belonging to the drilling pattern frame.
  2. Subsequently generate the drilling pattern again via the following command path: Tab Master data > Command group Drilling pattern / outline > Drop-down button Generate > From macro project (automatically).

Note:

Using a new check run (any desired scheme) this module-specific message can be deleted from the message management dialog.