This functionality is only available for certain module packages. Info / Copyright

P032002: The drilling pattern name <x> is repeated

Cause

The same drilling pattern name was assigned to several drilling patterns. The placeholder <x> in the message specifies the drilling pattern name that exists several times.

Solution

  1. Locate the drilling pattern name existing several times in the project using the Go to (graphic) function from the popup menu in the Message management dialog.
  2. Change the names one after the other in the dialog Properties <...> of the associated drilling pattern names so that each name occurs only once in the project.
  3. Click [OK] to apply the change respectively.
  4. Subsequently generate the drilling pattern again via the following command path: Tab Master data > Command group Drilling pattern / outline > Drop-down button Generate > From macro project (automatically).

Note:

Using a new check run (any desired scheme) this module-specific message can be deleted from the message management dialog.