Preconditions:

• You have opened a project containing pre-planning data.
• You have opened a page of the "P&I diagram" type.
• You have defined a piping in the P&I diagram by means of a piping definition point.

1. Select the following commands: Insert center > Breadcrumb trail Home > Symbols.
2. From the symbol library SPECIAL select the symbol PBR for a piping interruption.
3. In the preview select the corresponding variant of the interruption symbol for a vertical or horizontal piping section.
   
4. For the desired piping click the positions between which the interruption is to be inserted.
   
   The piping is not deleted between these two positions but only graphically interrupted.
5. Proceed in a similar way for all additional pipings that are to be interrupted.
6. End the action via the Cancel action popup menu item or via the [Esc] button.

See also

Piping Definitions in the P&I Diagram

Marking and Editing the Piping Route