Cause
There are at least two form positions by the same name for one or more targets at the first and / or second function connection point of the pin that was either generated in the plug navigator or placed in the schematic.
Solution
- Double-click in the plug navigator or in the schematic on the pin and select the Connections tab in the Properties <...> dialog.
- Name the form positions by the same name for the targets at the first and / or the second function connection point of the pin.
- If required, start a new check run.
Note:
The Connections tab is only available if you have activated the Use 'Connections' tab at terminals and pins setting. You access this setting with the following commands: File > Settings > Projects > "Project name" > Management > Compatibility.