Cause

You are using a user-defined property '<x>' in the project at objects (pages, macros, functions, etc.) for which certain default values <y>' were defined in a selection list by using the input aid '<z>' in the dialog Configure properties.

In the concrete case a value was used that was not a component of the selection list specified in the configuration dialog and is therefore reported as invalid.

Solution

Possibility 1

1. Locate the object in the project by means of the Find menu item. Or use the Go to (graphic) functionality from the popup menu of the dialog Message management to find the object on a schematic page.
2. Call up the property dialog of the object.
3. Select a valid default value '<y>' in the property table for the user-defined property '<x>' via the [...] button.
4. Click [OK].

Possibility 2

1. Select the following commands: Tab Tools > Command group Management > Properties.
2. In the dialog Configure properties add the manually added value '<y>' to the selection list of the user-defined property '<x>' by using the input aid '<z>'.
3. Click [OK].

---

If required, start a new check run.