Cause

Several causes are possible. These are output in the placeholder <x> of the message:

• No drilling pattern name available.
• Block not broken up.
• Outline not closed.
• No cut-out identified.

Solution

Depending on the respective cause the following solutions are possible:

1. First locate the drilling pattern frame in the project using the Go to (graphic) function from the popup menu in the Message management dialog.
   
   - Enter a name in the dialog Properties <...> of the drilling pattern frame.
   
   - Or break up the block into individual elements.
   
   - Or close the outline.
   
   - Or check the layer allocation of the objects belonging to the drilling pattern frame.
2. Subsequently generate the drilling pattern again via the following command path: Tab Master data > Command group Drilling pattern / outline > Drop-down button Generate > From macro project (automatically).