Cause

In the parts database to be checked a part was found where a drilling pattern is stored for which an outline was entered which EPLAN cannot find.

Solution

1. In the message management dialog mark the line with the message and select the Properties popup menu item.
   
   The Parts management dialog is opened, the respective part is already marked in it.
2. Bring the Manufacturing tab to the front.
3. In the property table in the Name (drilling pattern) column click the table entry and then click [...].
4. In the subsequent dialog open the list of available drilling patterns and mark the desired drilling pattern.
5. Bring the Cut-outs tab to the foreground in the right-hand section of the dialog.
6. In the Outline name column of the table enter an existing outline, or click [...] and select the outline in the subsequent dialog.
7. Click [OK].
8. Close the parts management, save the modified data, and carry out a parts synchronization.
9. If required, start a new check run.