In this dialog, enter the target coordinates where the cursor is to be positioned. Entry is relative to the point of origin of the coordinate system used.

The following dialog elements are available:

Current cursor position:

When the dialog is called up, the current position of the cursor is displayed. Enter the target coordinates in the X and Y fields.

Coordinate system:

In this group box, the coordinate system assigned via the page type is selected by default. You can temporarily switch coordinate systems, which influences the position of the base point (coordinate origin).

• Graphic: The graphical coordinate system has its origin on the bottom left. Coordinate values are entered in the unit "mm".
• Electrical engineering: The electrical engineering coordinate system has its origin in the upper left corner of the drawing area. Coordinate values are entered in grid increments.
• Fluid power: The fluid power coordinate system has its origin on the bottom left. Coordinate values are entered in grid increments.
• Process engineering: The process technical coordinate system has its origin at the bottom left. Coordinate values are entered in grid increments.

See also

Graphical Editor

Coordinate Systems

Moving the Coordinate Base Point

Entering Coordinates when Drawing

Dialog Relative coordinate input